澳規5V1A USB充電器
型號:JHD-AP008A-050100BB-A
認證:ROHS
產品尺寸:58*39.8*23mm
產品淨重:50g
產品描述:5V1A澳規USB充電器,開關電源適配器,變壓器
型號:JHD-AP008A-050100BB-A
輸入:AC100-240V,50/60hz,0.4A
輸出:DC5V1A
最大負載:1.1A(4.54Ω),最大功率:5.5W
插腳類型: AUS澳規2PIN。
耐壓強度(高壓):3000Vac /5mA Max / 60秒。
漏電流:在240Vac/50Hz輸入時最大為0.25mA。
絕緣阻抗:在初級與次級間加500Vdc 進行測試,最小50MΩ。
顏色:黑色,白色;其它顏色可以定製。
質保期:36個月。
包裝:
A:PE袋+紙箱
B:定製包裝。
安規認證:ROHS
安全保護:
4.1 Over Current Protection/過流保護
The power supply shall be in protection status when the over currents applied to the output rail, and shall be self-recovery when the fault condition is removed.
當過電流時,電源處於保護狀態,當過電流情況解除後,產品將會自動恢複正常。
4.2 Short Circuit Protection/短路保護
The input power shall decrease when the output of short ,the power supply shall no damage , and shall be self-recovery when the fault condition is removed.
當輸出短路時,產品輸入功率降低且不會損傷,當短路情況解除後,產品將會自動恢複正常。
4.3 Over Voltage Protection/過壓保護
When the output over-voltage, the power supply into the hiccup protection status,and shall be self-recovery when the fault condition is removed.
當輸出過壓時,電源進入打嗝保護狀態,當過壓狀況解除後,則會自動恢複正常。
環境要求:
工作溫度:-10℃到+40℃
儲藏溫度:在-20℃到 +85℃.
工作濕度:在10%到90%。
儲藏濕度:在5%到95%不結霜。
可靠性要求
Burn-in Test/老化測試
Adjust the input voltage to 220Vac and connect the output of the power supply to the Burn-in load,each resistant value is as following: 5Vdc/1000mA(5.0ohm)the power supply can undergo a minimum of 8 hours Burn-in test at 40±5℃.
將輸入電壓調節為220Vac,輸出接我司老化負載:5Vdc/1000mA(5.0ohm)在40±5℃的環境下老化8小時以上,老化後再按以上步驟進行測試,電源正常工作。
應用:
支持USB接口數據充電,給數碼產品充電,適用於手機平板等數碼產品。
![]() | 深圳寶安區福永鎮鳳凰興圍第三工業區22棟4~5樓 |
![]() | 0755-27335173 , 27335196 18038016909 , 13714239992 |
![]() | kevin@xinrongkj.com |
![]() | QQ: 316018708 , 182260739 |
© 2013 深圳市AG8亞洲隻為非同凡響0電子有限公司 All Rights Reserved USB充電器-5V/1A開關電源-5V/2A充電頭-USB電源適配器-5V3A開關電源